Amplifier modules by: Detonation Ground Sound Hypex Mivoc Monacor Omnes Audio Newtronics Sitronik Visaton and components Home

Mivoc Subwoofer Modules

Mivoc modules are characterised by their sheer unbelievable low prices. There is no competition for the AM 120 in its performance bracket.

In return you might have to experiment with the running of cable to avoid hum (85% of all hum problems are caused by incorrect cabling).

Explanation about the operation of subwoofer amplifiers
 

AM 80

Mivoc AM80                         EUR 78,00
... or in silver:                    - not available

technical data:
output: 80/160 Watt into 4 Ohm
cut-off frequency: adjustable 50-150 Hz, 12 db/oct
Subwoofer module with gain control, cut-off frequency control and phase inversion switch. RCA sockets (to connect to pre-amp out) and binding posts (to connect to the main amp) are available. The satellites maybe looped through the module. Outside dimensions (HxW): 247 x 180 mm, required cut-out (HxWxD): 220 x 150 x 90 mm.
 
  back to overview
AM 120

Mivoc AM120                         EUR 127,00
... or in silver:                      - not available

technical data:
output: 120/240 Watt into 4 Ohm
cut-off frequency: adjustable 50-150 Hz
slight bass boost (fixed)
Subwoofer module with gain control, cut-off frequency control and phase inversion switch. RCA sockets (to connect to pre-amp out) and binding posts (to connect to the main amp) are available. The satellites maybe looped through the module. The unit switches to energy-saving stand-by mode should after a few minutes no signal be detected; low bass correction (increase) is fixed at 30 Hz. Outside dimensions (HxW): 250 x 250 mm.
 
  zur Übersicht
FAM-90

Mivoc FAM-90                         - not available

technical data:
power output: 70/140 Watt max
frequency range: 70 - 20.000 Hz (-3 dB)
weight: 2,6 kg
Amplifier module with level control cut-off frequency control and phase inversion switch. RCA sockets (to connect to pre-amp out) and binding posts (to connect to the main amp) are available. The satellites maybe looped through the module. The unit switches to energy-saving stand-by mode should after a few minutes no signal be detected; low bass correction (increase) is fixed at 30 Hz.

Outside dimensions (HxWxD): 248 x 179 x 83 mm

manual in pdf format
 

  zur Übersicht
A3120 21

Mivoc MPA A 3120 2.1
amplifier module           EUR 147,00

technical data:
power output: 3 x 120 W R.M.S.
with two channels for the satellits
one for the subwoofer
frequency range
satellit: 130 - 20.000 Hz
subwoofer: 45 - 130 Hz
input voltage: 0.3 - 2.5 V
weight: 5 kg

amplifier module for a satellit subwoofer system with two satellits and one subwoofer. The impedance of the satellits must be 4 Ohm or higher. Because the A 3120 is not airtight a separation chamber is needed.
The module can be connected symmetrical to a source (for example a Mixer) using a 3 pin XLR-connector as well as an RCA plug (asymmetrical connection). The A 3120 is equipped with two power outputs for Speakon® compatible plugs. There is a MAIN level control and a SUB level control and phase inversion switch.

Outside dimensions (HxWxD) are: 31 x 36 x 10,3 cm; the cut-out dimensions (HxWxD) are 28 x 33 x 7 cm. The distance to any wall must be more than 5 cm.

manual in pdf format

  back to overview